OAR 918-098-1580
Specialized Electrical Inspector Certification
(1)
Scope of Activities and Authority.(a)
Specialized Electrical Inspectors may conduct electrical inspections in buildings less than 75 feet above grade as defined in the Oregon Structural Specialty Code where the building service or the feeder to the electrical installation being inspected is not more than 400 amps at less than 150 volts to ground or 200 amps at 150 volts or more to ground.(b)
A Specialized Electrical Inspector may not inspect any of the following:(A)
Separately derived systems, other than renewable energy, rated more than 150kw;(B)
Renewable energy systems rated more than 25kw;(C)
Occupancies classified as Assembly or Education, or any (I)-Institutional Occupancies as defined in the Oregon Structural Specialty Code;(D)
Installations governed by Chapter 5 or Articles 610, 668, 669, 695 and 700 of the Oregon Electrical Specialty Code, except for the following:(i)
Electrical connection to or alteration of a single mobile home, recreational vehicle or manufactured dwelling, including the service but excluding park construction, alteration or enlargement.(ii)
Agricultural buildings that do not contain excessive dust or corrosive areas as defined in the Oregon Electrical Specialty Code 547.1 (A) and (B).(E)
New or replacement motor loads over 100 HP.(2)
Procedure for Qualification. An applicant for certification under this rule must meet the general qualifications in OAR 918-098-1520 (Specialized Inspector Qualifications) and Section (3) of this rule, complete a training program that meets minimum requirements established by the division, make application, pay the required fees, and pass a division-approved examination.(3)
Experience, Education, and Training Requirements. Specialized Electrical Inspector Certification applicants must have:(a)
A current One- and Two-Family or Residential Electrical Inspector Oregon Code Certificate;(b)
Held a current One- and Two-Family or Residential Electrical Inspector Oregon Code Certificate for one year prior to applying for Specialized Electrical Inspector Certification; and(c)
Been employed as an inspector and performed inspections in the specialty code area listed in (a) above for a minimum of one year prior to applying for Specialized Electrical Inspector Certification.(4)
Certification. Upon completion of all training, and after passing a division-approved examination, the division will certify an applicant as a Specialized Electrical Inspector, and issue the appropriate documentation.
Source:
Rule 918-098-1580 — Specialized Electrical Inspector Certification, https://secure.sos.state.or.us/oard/view.action?ruleNumber=918-098-1580
.